Open the cover of the central unit and insert the card in the position as indicated in the picture. Fix the
Dante™ card by means of two screws and put the cover back on the central unit.
Supported Video Formats
SD SDI
PAL
NTSC
HD SDI
720p: 23.976, 24, 25, 29.97, 30, 50, 59.94 and 60 Hz
1080p: 23.976, 24, 25, 29.97 and 30 Hz
1080i: 50, 59.94 and 60 Hz
3G SDI
1080p: 50, 59.94 and 60 Hz
Factory Defaults Restore Button
Figure 1-5 Reset button on Plixus MME
Depending on the amount of seconds you press and hold the reset button, different outcomes are possible:
Press and hold the button for less than 5 seconds: the units will restart.
Press and hold the button for 5 up to 20 seconds: the IP address resets to the default IP
address and the unit restarts. This is indicated by the blinking LED lights of the unit.
Press and hold the button for more than 20 seconds: configurations are not cleared, but
inactivated, IP address is reset to the default IP address and the unit restarts. This is indicated by
the continiously lit LED lights.
PLIX US MME 28
To Next Page
Loading...
