Televic Plixus Series - Configuration with Plixus AE-R and Lingua Ids

Configuration With Plixus AE-R And Lingua IDs
When your setup contains an audio-only engine and many interpreter booths, it is best not to mix the
interpreter desks with other delegate or chairperson units on the same branch. Consequently, at least one
branch of the engine only contains Lingua IDs. For large setups, it is best practice to create loops with or
without network extenders, to guarantee a fully functional system even if one unit fails. Therefore, you
should devote two branches to the interpreter desks.

FLOOR MICROPHONE MUTE
! " # $ % & ' 
FLOOR MICROPHONE MUTE
! " # $ % & ' 
FLOOR MICROPHONE MUTE
! " # $ % & '

FLOOR MICROPHONE MUTE
! " # $ % & ' 
FLOOR MICROPHONE MUTE
! " # $ % & ' 
FLOOR MICROPHONE MUTE
! " # $ % & '

FLOOR MICROPHONE MUTE
! " # $ % & ' 
FLOOR MICROPHONE MUTE
! " # $ % & ' 
FLOOR MICROPHONE MUTE
! " # $ % & '

FLOOR MICROPHONE MUTE
! " # $ % & ' 
FLOOR MICROPHONE MUTE
! " # $ % & ' 
FLOOR MICROPHONE MUTE
! " # $ % & '
televic
televic televic televic
televic televic televic
48 V
48 V
48 V
48 V
Figure 1-30 How to set up an audio-only system with a large amount of Lingua IDs
INSTAL L ATIO N DIAG RAM 60