Televic Plixus Series - Rear End Connectivity; Power Supply; Factory Defaults Restore Button

Rear End Connectivity
Dante
TM
LAN
USB
PORT 1
1
ON WE
2 3 4
PORT 2 PORT 3 PORT 4
CONFERENCE NETWORK (CN)
48 V / 2A OUT (4x)
AUX OUT
AUX IN
48 V IN
MAX 420W
1
2 3
5
6 7
8
9
4
Figure 1-8 Back view of Plixus AE-R
1. On/off switch
2. Two power connectors for power supply injection
3. Plixus conference ports
4. DIP switch: each switch enables and disables 48V power to the corresponding conference port
5. Two redundant Dante™ network ports
6. Balanced (XLR) and two unbalanced (RCA) audio outputs
7. Balanced (XLR) and two unbalanced (RCA) audio inputs
8. USB 2.0 port to plug in USB device for audio recording
9. LAN port
Power Supply
The Plixus AE-R does not have an internal power supply. By default one external power supply of 220W is
delivered together with the engine. You can use a second power supply for redundancy. However for larger
setups you need the additional power to power the units, preventing you to use the second power supply for
redundancy. See "Power supply design" on page61
Factory Defaults Restore Button
Figure 1-9 Reset button on Plixus AE-R
Depending on the amount of seconds you press and hold the reset button, different outcomes are possible:
PLIX US AE- R 30