Portable Wireless AP/Router
² IP Address: Enter the IP address of the PC where you
want to set the applications.
² Protocol: Select the protocol (TCP/UDP/Both) for the
application.
² Enable: Click to check it for corresponding operation.
² Delete: Click to clear the parameters.
² Well-Known Service Port: Select the well-known
services as DNS, FTP from the drop-down menu to
add to the configured one above. For the port not in
the list, you can input manually.
² Add: Add the selected well-known port to the policy
ID.
The server at the IP address of 192.168.2.10 in LAN
provides WEB service at the port of 80 and Telnet service at
the port of 23. If you want the clients on the Internet to visit
this server, please set the device as the diagram above.
NOTE: If you set the virtual server of the service port as 80,
you must set the Web management port on Remote Web
Management page to be any value except 80 such as 8080.
Otherwise, there will be a conflict to disable the virtual
server.
To Next Page
Loading...
Need help?
General
