Terex MAC 25 User Manual

MAC-25 OFFSET HEAD BOTTOM POSITION LOAD CHART - 40 DE
G
LMI DUT
Y
203
COUNTERWEIGHT ON REAR OF CRANE - SPRING LOCKOUTS ENGAGED
S.W.L. ARE BASED ON 66.7% STABILITY & STRENGTH
S.W.L IN KILOGRAMS FOR SLEW ANGLES OF GREATER THAN 10 DEGREES UP TO 40
- S.W.L. ABOVE BOLD RED LINE ARE STRUCTURAL
DEGREES EITHER SIDE OF STRAIGHT AHEAD (INDICATED BY RED LED ON DASH).
S.W.L. ARE BASED ON FIRM LEVEL GROUND (1% SLOPE (0.6 DEG) AS PER AS1418.5)
BOOM ANGLE - UNDEFLECTED (REF.)
WITH TYRES INFLATED AS PER NOTES
NOTE :
VALUES IN BRACKETS ( ) ARE ACTUAL RADIUS AT ZERO DEG. BOOM ANGLE.
LIFT & CARRY - THE S.W.L. SHALL BE CARRIED WITH THE MINIMUM BOOM LENGTH & AS
CLOSE TO THE GROUND AS POSSIBLE AT SPEEDS NOT IN EXCESS OF 0.4 M/SEC (1.44 KM/HR)
Radius BOOM PIVOT TO EDGE OF SHEAVE - THIRD BOOM RETRACTED THIRD BOOM EXTENDING
in (metres) (metres)
Metres 6.86 7.00 7.50 8.00 8.50 9.00 9.50 10.00 10.50 11.00 11.50 12.00 12.50 13.00 13.50 14.00 14.50 15.06 15.50 16.00 16.50 17.00 17.50 18.00 18.50 19.16
1.4
8400 8400 8400 8400 8400 8400
55 56 59 61 63 65
2.0
8400 8400 8400 8400 8400 8400 8400 8400 8400
WINCH S.W.L.
49 50 53 56 58 60 62 64 65 SINGLE PART 4200
2.5
8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 TWO PARTS 8400
43 44 48 51 54 56 58 60 62 63 65
3.0
8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8300
36 38 43 46 50 52 55 57 59 60 62 63 64 65
3.5
8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8400 8300 8000 7750 7500 7250
27 30 36 41 45 48 51 53 55 57 59 60 62 63 64 65
4.0
8400 8400 8400 8400 8400 8400 8400 8400 8400 8300 8050 7750 7450 7200 7000 6750 6550 6350
(4.2) 19 29 35 40 44 47 50 52 54 56 58 59 60 62 63 64 65
5.0
8400 7950 7600 7550 7550 7550 7500 7300 7050 6800 6600 6400 6250 6100 5900 5750 5550 5450 5350 5250 5150 5050
(4.3) (4.8) 18 27 33 38 41 44 47 49 52 53 55 57 58 59 61 61 62 63 64 65
6.0
7050 6300 6050 6050 6000 6000 6000 5900 5700 5550 5350 5250 5100 5000 4850 4800 4700 4650 4550 4500 4450 4350 4300
(5.3) (5.8) 17 25 31 36 39 42 45 47 49 51 53 54 56 57 58 59 60 61 62 63 64
7.0
5650 5100 4950 4950 4950 4900 4900 4850 4700 4550 4450 4350 4250 4200 4150 4100 4050 4000 3950 3900 3850
(6.3) (6.8) 16 24 30 34 37 40 43 45 47 49 51 52 54 55 56 57 59 59 61
8.0
4650 4250 4100 4100 4100 4100 4100 4050 3950 3850 3750 3700 3650 3600 3600 3550 3500 3500 3450
(7.3) (7.8) 15 23 28 33 36 39 41 44 46 48 49 51 52 53 55 56 57
9.0
3900 3550 3450 3450 3450 3450 3450 3400 3300 3300 3250 3200 3200 3150 3150 3100 3050
(8.3) (8.8) 14 22 27 31 35 37 40 42 44 46 48 49 51 52 53
10
3300 3050 2950 2950 2950 2950 2950 2950 2900 2900 2850 2850 2800 2800 2750
(9.3) (9.8) 14 21 26 30 34 36 39 41 43 45 46 48 50
11
2800 2600 2550 2550 2550 2550 2600 2600 2600 2550 2550 2550 2500
(10.3) (10.8) 13 20 26 29 32 35 37 40 42 43 45
12
NOTE : WEIGHT OF HOOKS, BLOCKS & OTHER 2400 2250 2200 2200 2250 2300 2300 2350 2300 2300 2300
LOAD HANDLING DEVICES SHALL BE ADDED (11.3) (11.8) 14 20 24 28 31 34 36 39 41
13
TO THE WEIGHT OF THE LOAD 2050 1950 1950 2000 2050 2050 2100 2100 2100
(12.4) (12.8) 12 19 24 27 30 33 36
14
1850 1800 1800 1800 1850 1850 1900
(13.3) (13.8) 12 18 23 27 30
15
1700 1600 1600 1650 1700
(14.3) (14.8) 12 18 24
16.4
1550 1500 1400
(15.3) (15.8) (16.4)
38/66 MXC1347B COUNTERWEIGHT - REAR MAC 25 OFFSET HEAD BOTTOM POSITION - 40 DEG

Terex MAC 25 Specifications

General

Brand	Terex
Model	MAC 25
Category	Construction Equipment
Language	English