Terumo CDI 550 - Chapter 3 Setting Up the Hardware; Chapter 4 Choosing System Settings; Chapter 5 Calibrating Sensors; Chapter 6 Installing Disposables

ii
Setting up and starting calibration
....................................................................... 5-1
Concluding calibration ......................................................................................... 5-8
Verifying calibration .............................................................................................. 5-9
Preparing to install sensors ................................................................................. 6-1
Installing the Shunt Bypass Line and CDI H/S Cuvette ....................................... 6-1
Installing a CDI Shunt Sensor ............................................................................. 6-2
Installing a CDI Shunt Sensor into the Shunt Bypass Line .................................. 6-4
Attaching the CDI H/S Probe for Hematocrit/Saturation measurement ............... 6-6
Initiating “operate” mode ...................................................................................... 7-1
Completing Calibration of the CDI System 550 measurements .......................... 7-3
Choosing display modes ...................................................................................... 7-5
Setting the patient temperature mode ................................................................. 7-8
Entering the blood flow rate ( ) ........................................................................... 7-8
Recalibrating during a procedure ........................................................................ 7-9
Batteries contained within the CDI System 550 ................................................ 7-11
System Batteries ........................................................................................... 7-11
Operating on emergency battery power ....................................................... 7-11
Selecting options on the setup screens ............................................................... 4-1
Setting printer options .......................................................................................... 4-2
System Notifications ............................................................................................ 4-3
Physiological Alarms............................................................................................ 4-4
Manufacturer-Defined Default Alarm Limits ......................................................... 4-4
Setting alarms ...................................................................................................... 4-5
Choosing graphic displays ................................................................................... 4-7
Choosing general settings ................................................................................... 4-9
Specifying values used in calculations .............................................................. 4-10
Setting parameters for communicating with an external device ......................... 4-12
Chapter 7
Monitoring a Patient
Chapter 5
Calibrating Sensors
Chapter 6
Installing Disposables
Chapter 4
Choosing System Settings
Table of contents