TESTO 310 II - Page 48

9 Smart App
48
WARNING
Hot probe shaft! Risk of burns!
> Allow the probe shaft to cool down after a measurement,
before touching it!
> Only attach the silicone hose to the probe shaft once it has
cooled down!
7
Fit silicone hose onto the probe shaft
of the flue gas probe. The probe
shaft openings must be closed.
Carry out the measurement
✓
The silicone hose must be clear (pressureless, no kinks).
1
Start measurement: [Start].

Pressure zeroing.
2
Connect the silicone hose to the sampling point.
3
Pressurise the system.

The reading is displayed.
4
Quit measurement: [Stop].
5
Save measured values in the app: [Save].
After the measurement
1
Open filter chamber of the flue gas probe: turn it gently anti-clockwise.
2
Remove the sealing plug from the gas path.
3
Insert the particle filter again into the gas path and check that it is
fitted securely.
4
Close filter chamber of the flue gas probe.
5
Remove silicone hose from the probe shaft.