Texas Instruments AFE5832 - Default Jumper Positions

49
SLOU489–August 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
Hardware Configuration
Appendix C
SLOU489–August 2017
Hardware Configuration
C.1 EVM Headers, Test Points, and Configuration
This section describes the functions of the headers on the EVM. It also provides a list of test points on the
EVM that are useful for debug and general-use purposes.
C.1.1 EVM Header Configuration
The AFE5832 EVM is flexible in its configurability through the use of 2- and 3-pin headers. The default
configuration of the EVM is set to facilitate initial testing, requiring minimal bench equipment. Figure 60
shows the default positions of all headers.
Figure 60. Default Jumper Positions