www.ti.com
BP-ADS7128 EVM Initial Setup
7
SBAU331–May 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
BP-ADS7128 BoosterPack™ Plug-In Module
3.2 UNIFLASH Programmer for MSP-EXP432E401Y Software Programming
The MSP432E401Y LaunchPad™ ships with a default firmware program flashed on its memory. When a
LaunchPad™ is connected to the PC for the first time, its firmware must be updated for communications
with the BP-ADS7128. The following steps describe how to program this firmware on the flash memory:
1. On the MSP432E401Y LaunchPad™, remove jumper JP6 from its default position and place this
jumper on the JP1 jumper, as shown in Figure 4, at location 5V-OTG.
Figure 4. MSP432E401Y LaunchPad™ 5V-OTG Jumper
To Next Page
Loading...
