Configuring the TI-Nspire™ CX handheld 55
Configuring the TI-Nspire™ CX handheld
This chapter provides information needed to:
• Maintain batteries used in the handheld
• Change the default settings
• Attach a wireless module when the handheld is used in the classroom
Checking battery status
To check the status of the TI-Nspire™ Rechargeable Battery in a
handheld:
1. Press
c to access the Home screen.
2. Press
54 to open the Handheld Status window.
3. Click
OK or press · to close the window.
Note: From an open document, press
~74.
Recharging the handheld
To recharge the TI-Nspire™ Rechargeable Battery in a handheld, connect
it to either of the following power sources:
• A standard USB cable connected to a computer
• A TI USB wall charger (sold separately)
• A TI-Nspire™ CX Docking Station if in a classroom setting
The amount of time required to fully charge the battery may vary, but
charging normally takes about six hours. It is not necessary to remove the
TI-Nspire™ Rechargeable Battery from the handheld to recharge it. The
handheld operates normally while it is attached to a charging source.
Battery status
is shown here.
To Next Page
Loading...
Need help?
General
