BHT-212-MM-1
5-00-00
Page 48 Rev. 14 26 JUN 2013
Export Classification C, ECCN EAR99
— Restoration
1. Clean chip detectors.
— Functional Check
1. Test chip detectors electrical circuits.
Chapter 95 INSTRUMENTS
The following checks are required every 12 months
only.
1. Calibrate pilot and copilot compass systems and standby
magnetic compass.
2. Drain pitot-static system of any accumulated moisture.
3. Test pitot-static system for leaks.
Chapter 96 ELECTRICAL SYSTEM
1. Check inverters for security of mounting and connections.
2. Check generator control units for damage and security of
mounting and terminals.
3. All exposed wire bundles, bundle supports and connectors
for damage, corrosion, and security. Pay particular attention to
engine deck connectors and harnesses.
4. Inspect relays and main bus area for security of mounting
and connections.
5. Inspect bus insulation for damage and condition.
6. Operationally check cabin heater system, bleed air shutoff,
and line check valve.
5-9. 100 HOURS/12 CALENDAR MONTHS — PART A (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
