BHT-212-MM-1
5-00-00
26 JUN 2013 Rev. 14 Page 47
Export Classification C, ECCN EAR99
2. Right power section starter generator cooling ducts for
obstruction, kinking, and security.
3. Left power section starter generator brushes for allowable
wear.
4. Right power section starter generator brushes for allowable
wear.
Chapter 76 ENGINE CONTROLS
1. Check controls for smooth movement through full range of
travel.
Every third 100 hour inspection (300 hours) or 12 months:
1. Engine fuel and power controls:
a. Engine control linkages for looseness, lost motion,
chafing, damage, and security of attachment.
b. Bellcranks, mounts, and jackshafts for looseness,
damage, and security of attachment.
Every sixth 100 hour inspection (600 hours) or 12 months:
1. Perform maximum N
G
topping check.
Chapter 71 COMBINING (REDUCTION) GEARBOX
Refer to Pratt & Whitney Canada PT6T-3/-3B
Maintenance Manual for engine inspection
requirements.
Every third 100 hour inspection (300 hours) or 12 months:
— Detailed Visual Inspection
1. Chip detectors for debris.
5-9. 100 HOURS/12 CALENDAR MONTHS — PART A (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
