39
hoses. If there are any portions of the hose that have
decals. Replace any missing or illegible decals.
3. Make sure all shields are in place and in good
condition. Repair or replace any missing or damaged
shields.
4. Perform lubrication per instructions.
5. Listen for abnormal sounds, which might indicate
6. With the engine off, engage the blower assembly.
Correct any deficiency before continuing operation.
cracks or tears.
7. Check for wear or deterioration of the upper or lower
loose parts, damaged bearings, or other damage.
Check the belt tension and inspect the pulley belt for
been torn or worn through, replace immediately.
After Each Use:
1. Clean all debris from machine especially from the
container, underneath the belt shields, and safety
2. Inspect the unit for worn or damaged components.
include the component’s current safety decal specified
deterioration and wear and should therefore be
Repair or replace before the next use. Any
by the manufacturers to be affixed to the component.
replacement bag should be checked to ensure
compliance with the original manufacturer’s
replacement component installed during repair shall
recommendations or specifications.
4. Check belt for proper tension.
frequently checked for necessary replacement. Any
3. Under normal usage, the bag material is subject to
DOCUMENT THE FOLLOWING INFORMATION FOR FUTURE REFERENCE
Dealer/Distributor Name:__________________________________________
Date of purchase:________/________/_________
Unit Model Number:_______________________________________________
Address: _________________________________ State:_______ Zip:_______
Unit Serial Number:________________________________________________
Phone Number: ____________________________________________________
Unit Engine Size:__________________________________________________
Fax: 828-684-0858
Phone: 1-800-438-5823 | 828-684-1234
Website: www.lawnvac.com
10 Walden Dr | Arden, North Carolina 28704
New PECO, Inc.
Email: peco@lawnvac.com
Gearbox:
Replace the oil using 5.5 oz. of the recommended
Mobilube HD Plus 80W-90 oil. Be sure to not overfill.
NOTE: The following is for older PTO models that
contain a greaseable zirc fitting. Newer models
Operators are recommended to check for leaks weekly.
If a leak is observed, both the gasket and the seals are
recommended to be replaced.
contain maintenance-free bearings and are without
Blower Assembly:
a greasable fitting.
.
1. On initial use: Grease the fitting on the blower shaft.
2. Every 25 hours of use: Re-grease the grease fitting.
4-2 Lubrication
NOTE: The gearbox is filled with 6.0 oz. of Mobilube
HD Plus 80W-90 oil and permanently sealed. There is
no need for scheduled lubrication. The oil level should
only be checked if a leak is observed or if a change in
gearbox noise is noticed.
lubrication of the shaft on the blower assembly.
5-1 Parts And Service Information
Collection system owners should record the name and
telephone number of their Service Center. Your Service
Center will be happy to supply replacement parts,
accessories, and do any service or repairs to your
collection system. If for any reason your Service Center
is unable to service your collection system or supply
replacement parts, contact New PECO, Inc. and include
the following information on the chart below.
NOTE: Use only white lithium based grease for
SECTION V - PARTS & SERVICE
To Next Page
Loading...
Need help?
General