AS 680/682
Description, Operation and Maintenance Installation and Setup
ADS−B
3−31Ed. 10.07
17 Go to the GPS page.
18 Verify that the field Satellites: Number shows at least five satellites (required for useful opera-
tion).
19 Verify that the measured GPS WGS−84 Positions roughly corresponds to the configured GS
Reference Position of the Ground Station. The difference is shown in the field GPS Posi-
tion Deviation. Document both the measured lat/lon and the configured lat/lon in the SIR.
20 Verify that the Auxiliary Asterix Data Stream is enabled and set to the Host IP
192.168.23.2 (that of the LCMS), and that the Port is set correctly to 50000.
21 Change the visible desktop window by selecting one of the blue areas within the desktop panel
at the bottom of the desktop. Select an empty desktop the window.
22 Start the Technical Situation Display TSD from either the ADS−B tools menu of the
desktop panel or from the context menu activated with a right mouse click on the desktop back-
ground.
23 Within the TSD, set the Selected Interface to lcmsmaint:50000 and push OK.
24 Select from the preferences menu the item GS Filter to open the GS Filter Window.
25 Select the Ground Station under test from which you wish to receive data of from the list and close
the window.
26 Select from the preferences menu the item View to open the Selected Loc Window.
27 Select the Ground Station name from the drop down list View of groundstation to adjust
the correct map section.
28 Verify that at lease a Target with a label containing the name Thales is displayed. The first line of
the label must show the own site monitor address as configured.
29 Left−click on that label to select the test target.
30 Open the Target Details panel (if not already open) from the menu Display|Show Details
to show all the message contents of the test target report sent via Asterix.
31 Verify that the test target Time of Day is updated twice per second.
32 Verify that the Test Target Signal Amplitude corresponds to the one your were seeing before
within the Raw Data in section 2.5 step 30 and that is logged into the SIR.
3.6.7 Network Connection to RCMS
1 Call the TSS (responsible Technical System Supervisor) operating the RCMS, ask to check
whether the Ground Station is visible and its status can be retrieved.
2 Ask TSS to access Ground Station parameters.
3 Ask TSS to login into the Ground Station using the Login button on TSC software page.
4 Ask TSS to record Asterix data from this Ground Station to verify if any Asterix data can be received.
3.6.8 Site Installation Report (SIR)
If all the above mentioned tests were successful, the Ground Station installation should be accepted.
The following form is an example to be used as report for the site verification test.
To Next Page
Loading...