Thermal Dynamics A80 User Manual

A80
APPENDIX 0-4985
A-2
1/3
f
f
1
2
West Lebanon, NH USA 03784
Made in USA
Model:
U
1
1
1
1max 1e
I
I
U
2
3Ø
3Ø1Ø
1Ø
S/N
U
0
=
X
Standard Symbols
Ø
AC
DC
Phase
NOTES:
1. Symbol shown indicates single- or three-phase AC input,
static frequency converter-transformer-rectier, DC output.
2. Indicates input voltages for this power supply. Most power
supplies carry a label at the input power cord showing input
voltage requirements for the power supply as built.
3. Top row: Duty cycle values.
IEC duty cycle value is calculated as specied by
the International ElectroTechnical Commission.
TDC duty cycle value is determined under the power supply
manufacturer's test procedures.
Second row: Rated cutting current values.
Third row: Conventional load voltage values.
4. Sections of the Data Tag may be applied to separate areas
of the power supply.
I
Art # A-03288_AC
Date of Mfr:
Output Range (Amperage/
Voltage)
Type of Power
Supply (Note 1)
Output Current Type
Rated No-
Load Voltage
Plasma Cutting
Symbol
Manufacturer's Name and/or
Logo, Location, Model and
Revision Level, Serial Number
and Production Code
Conventional
Load Voltage
Regulatory Standard Covering
This Type of Power Supply
Duty Cycle Data (Note 3)
Duty Cycle Factor
Input P
ower
Specications
(Phase
, AC or DC
Her
tz Rating)
Input Power
Symbol
Rated Supply
Voltage (Note 2)
Rated Maximum
Supply Current
Maximum Eective
Supply Current
Degree of Protection
Manufacturer's Electrical
Schematic File Number
and Revision Level
®
APPENDIX 2: DATA TAG INFORMATION

Thermal Dynamics A80 Specifications

General

Brand	Thermal Dynamics
Model	A80
Category	Cutter
Language	English