Thermal Dynamics A80 User Manual

A80
0-4985 INTRODUCTION
2-1
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
This Owner’s Manual applies to just specication or part
numbers listed on page i.
To ensure safe operation, read the entire manual, including
the chapter on safety instructions and warnings.
Throughout this manual, the words WARNING, CAUTION,
and NOTE may appear. Pay particular attention
to the information provided under these headings.
These special annotations are easily recognized as
follows:
NOTE!
An operation, procedure, or background
information which requires additional em-
phasis or is helpful in ecient operation of
the system.
!
!
CAUTION
A procedure which, if not properly fol-
lowed, may cause damage to the equip-
ment.
!
!
WARNING
A procedure which, if not properly fol-
lowed, may cause injury to the operator or
others in the operating area.
WARNING
Gives information regarding possible
electrical shock injury. Warnings will be
enclosed in a box such as this.
Additional copies of this manual may be purchased by
contacting Thermal Dynamics at the address and phone
number in your area listed in the inside back cover of
this manual. Include the Owner’s Manual number and
equipment identication numbers.
Electronic copies of this manual can also be downloaded at
no charge in Acrobat PDF format by going to the Thermal
Dynamics web site listed below and clicking on Thermal
Dynamics and then on the Literature link:
www.thermal-dynamics.com
2.02 Equipment Identication
The unit’s identification number (specification or part
number), model, and serial number usually appear on a
data tag attached to the rear panel. Equipment which does
not have a data tag such as torch and cable assemblies are
identied only by the specication or part number printed
on loosely attached card or the shipping container. Record
these numbers on the bottom of page i for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against the invoice
to make sure it is complete and inspect the equipment for
possible damage due to shipping. If there is any damage,
notify the carrier immediately to le a claim. Furnish com-
plete information concerning damage claims or shipping
errors to the location in your area listed in the inside back
cover of this manual.
Include all equipment identication numbers as described
above along with a full description of the parts in error.
Move the equipment to the installation site before un-crating
the unit. Use care to avoid damaging the equipment when
using bars, hammers, etc., to un-crate the unit.

Thermal Dynamics A80 Specifications

General

Brand	Thermal Dynamics
Model	A80
Category	Cutter
Language	English