WARNING
Read and understand this entire Manual and your employer’s safety practices before
installing, operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best
judgment, the Manufacturer assumes no liability for its use.
Plasma Cutting Power Supply
A80
SL100 1Torch™
Operating Manual Number 0-4985
Published by:
Thermal Dynamics Corporation
2800 Airport Rd.
Denton, Texas 76207
Phone: +01 800 426 1888, FAX +01 603 298 7402
www.thermal-dynamics.com
Copyright 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2017, 2018 by
Thermal Dynamics Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher
is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any
loss or damage caused by any error or omission in this Manual, whether such error results
from negligence, accident, or any other cause.
For Printing Material Specification refer to document 47x1909
Original Publication Date: June 30, 2008
Revision Date: March 10, 2020
Record the following information for Warranty purposes:
Where Purchased:_______________________________ __________________
Purchase Date:__________________________________ _________________
Power Supply Serial #:___________________________ __________________
Torch Serial #:___________________________________ _________________
i
To Next Page
Loading...
Need help?
General
