Thermal Dynamics A80 User Manual

EU DECLARATION OF CONFORMITY
According to
The Low Voltage Directive 2014/35/EU, entering into force 20 April 2016
The EMC Directive 2014/30/EU, entering into force 20 April 2016
The RoHS Directive 2011/65/EU, entering into force 2 January 2013
Type of equipment
PLASMA CUTTING POWER SUPPL
Y
Type designation etc.
A80 w SL100 SV Torch, from serial number 845-XXX-XXXX
Brand name or trade mark
Thermal Dynamics
Manufacturer or his authorised representative established within the EEA
Name, address, telephone No:
Thermal Dynamics Corporation
2800 Airport Rd.
Denton, Texas 76207 USA
Phone: +01 800 426 1888, FAX +01 603 298 7402
The following harmonised standard in force within the EEA has been used in the design:
IEC/EN 60974-1:2017/AMD1:2019 Arc Welding Equipment - Part 1: Welding power sources.
IEC/EN 60974-10:2014 + AMD 1:2015 Published 2015-06-19 Arc Welding Equipment - Part 10: Electromagnetic
compatibility (EMC) requirements
Additional Information: Restrictive use, Class A equipment, intended for use in location other than residential.
By signing this document, the undersigned declares as manufacturer, or the manufacturer’s authorised
representative established within the EEA, that the equipment in question complies with the safety
requirements stated above.
Date Signature Position
20 August, 2019
John Boisvert
Vice President,
Global Cutting
Mechanized Cutting
2019

Thermal Dynamics A80 Specifications

General

Brand	Thermal Dynamics
Model	A80
Category	Cutter
Language	English