Thermal Dynamics CUTMASTER A80 - Section 2 System:introduction; How to Use this Manual; Equipment Identification; Receipt of Equipment

Manual 0-5119 2-1 INTRODUCTION
CUTMASTER A80, A120
2.01 How To Use This Manual
This Owner’s Manual applies to just specication
or part numbers listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING,
C AU T I O N , a n d N OT E m a y a p p e a r.
Pay particular attention to the information
pr ov id ed un de r t he se he ad in gs . Th es e
special annotations are easily recognized as
follows:
!
WARNING
A WARNING gives information regarding
possible personal injury.
CAUTION
A CAUTION refers to possible equipment
damage.
NOTE
A NOTE offers helpful information concerning
certain operating procedures.
Additional copies of this manual may be purchased
by contacting Thermadyne at the address and
phone number in your area listed in the inside back
cover of this manual. Include the Owner’s Manual
number and equipment identication numbers.
Ele c tr o ni c cop i es o f t h is m anu a l c a n
a l s o b e downl o a d e d at n o c h a r g e i n
Acr o bat P DF f o rm a t b y goi n g t o th e
Thermal Dynamics web site listed below and
clicking on Thermal Dynamics and then on the
Literature link:
http://www.thermal-dynamics.com
2.02 Equipment Identification
The unit’s identication number (specication
or part number), model, and serial number
usually appear on a data tag attached to the
rear panel. Equipment which does not have a
data tag such as torch and cable assemblies are
identied only by the specication or part number
printed on loosely attached card or the shipping
container. Record these numbers on the bottom of
page 1 for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against
the invoice to make sure it is complete and inspect
the equipment for possible damage due to ship-
ping. If there is any damage, notify the carrier
immediately to le a claim. Furnish complete
information concerning damage claims or ship-
ping errors to the location in your area listed in
the inside back cover of this manual.
Include all equipment identication numbers as
described above along with a full description of
the parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging
the equipment when using bars, hammers, etc., to
un-crate the unit.
SECTION 2 SYSTEM:
INTRODUCTION