Thermal Dynamics CUTMASTER A80 - 04 Options and Accessories

CUTMASTER A80, A120
INTRODUCTION 2T-2 Manual 0-5119
C. Torch Parts
Starter Cartridge, Electrode, Tip, Shield Cup
D. Parts - In - Place (PIP)
Torch Head has built - in switch
12 vdc circuit rating
E. Type Cooling
Combination of ambient air and gas stream
through torch.
F. Torch Ratings
Automated / Machine Torch Ratings
Ambient
Temperature
104° F
40° C
Duty Cycle
100% @ 100 Amps @ 400 scfh
80% @ 120 Amps @ 400 scfh
Maximum
Current
120 Amps
Voltage (V
peak
)
500V
Arc Striking
Voltage
7kV
Manual Torch Ratings
CUTMASTER A80
Ambient
Temperature
104° F
40° C
Duty Cycle 100% @ 100 Amps @ 400 scfh
Maximum
Current
120 Amps
Voltage (V
peak
) 500V
Arc Striking
Voltage
7kV
Manual Torch Ratings
CUTMASTER A120
Ambient
Temperature
104° F
40° C
Duty Cycle 100% @ 120 Amps @ 400 scfh
Maximum
Current
120 Amps
Voltage (V
peak
) 500V
Arc Striking
Voltage
7kV
G.Gas Requirements
Automated, Manual and Machine Torch Gas
Specications
Gas (Plasma and Secondary) Compressed Air
Operating Pressure
Refer to NOTE
60 - 95 psi
4.1 - 6.5 bar
Maximum Input Pressure 125 psi / 8.6 bar
Gas Flow
(Cutting and Gouging)
300 - 500 scfh
142 - 235 lpm
!
WARNING
This torch is not to be used with oxygen (O
2
).
NOTE
Operating pressure varies with torch model,
operating amperage, and torch leads length.
Refer to gas pressure settings charts for each
model.
H. Direct Contact Hazard
For standoff tip the recommended standoff is 3/16
inches / 4.7 mm.
2T.04 Options And Accessories
For options and accessories, see section 6.