WARNINGS
Read and understand this entire Manual and your employer’s safety practices before installing,
operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement,
the Manufacturer assumes no liability for its use.
i
Plasma Cutting Power Supply
CutMaster™ A80 SL100SV Torch™ Operating Manual No.: 0-5119
CutMaster™ A120 SL100SV Torch™ Operating Manual No.: 0-5119
Published by:
Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
Copyright 2008, 2009 by
Thermadyne Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the
publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any
loss or damage caused by any error or omission in this Manual, whether such error
results from negligence, accident, or any other cause.
Original Publication Date: December 10, 2008
Revision Date: October 20, 2009
Record the following information for Warranty purposes:
Where Purchased:_________________________________________________
Purchase Date:____________________________________________________
Power Supply Serial #:_____________________________________________
Torch Serial #:_____________________________________________________
To Next Page
Loading...
