2 Important information/Safety regulation
2.1 General safety precautions
Carefully follow the precautions listed as below because they are essential to guarantee the safety of Thermia product. Store the manual
in a safe place in order to be able to use it as reference after installation. Remember to hand it over to the new owner if the heat pump
unit is sold or transferred. To prevent serious damage on the system and injuries to users, precautions and other notices shall be ob-
served.
Danger Risk of personal injury! Children are not permitted to play with the
product.
Danger Always disconnect the power supply of the heat pump before servic-
ing it or accessing components inside the unit.
Danger Electrical current is stored for a while in the electronics after you dis-
connect the power supply, because the unit contains capacitors which
may be charged. Make sure you wait before performing any work in
the heat pump after turning off the power.
Warning Installation and testing operations must be performed by qualified
personnel.
Warning The manufacturer shall not be responsible for damage originating
from unauthorized changes or the improper connection of electric or
hydraulic lines. Failure to comply with these instructions or to comply
with the requirements, included in the manual, shall immediately inva-
lidate the warranty.
Warning Do not use the units if you see any damages on the units, hear loud
noise, or the smell of burning.
Warning If the unit produces smoke, is very noisy or if any of the cables are hot
or damaged, always use the circuit break to turn off the unit and con-
tact the heat pump supplier.
NOTE: During the defrost sequence, it is normal for some steam to
leave the outdoor unit.
Installation Guide Athena
AWAT01IGCG0102 Thermia AB
6
To Next Page
Loading...
Need help?
General
