4. Save method.
To save the method to the instrument Library or disk, press the Save
Method function key and follow the on screen instructions.
5. Load a method from the instrument Library or from disk.
To do this, press the function key or press Library.
6. Remove any unwanted samples from sample compartment.
7. Insert a suitable reference, if required, and close the lid of the
sample compartment.
8. Press Zero to measure a baseline.
9. Open lid of the sample compartment and insert the sample and
then close the lid.
10. Press Run.
The Scan Graph page will appear.
11. Press the Manipulate function key to open the Manipulate menu
and choose the post run manipulation required.
Thermo Fisher Scientific Evolution 300 and Evolution 600 User Guide 43
To Next Page
Loading...
