EPD/HB/40521/000
ISSUE 5
EPD TECHNICAL HANDBOOK Page 26
3.5 Display Options and Button Functions
The following sections describe typical displays that a user may see within each of
the menus shown in Figure 3.4. This description assumes that all displays are
enabled. The user may have access to any (or none) of the displays, depending on
how the EPD has been configured. To call up a top-level display, press and hold the
button until the relevant top-level display appears. Any sub-displays are selected
either by short-pressing, or double-pressing, the button within the display default
time-out.
3.5.1 Displaying Hp (10) Dose, Dose Rate and User ID.
To display Hp(10) doses, press
and hold the button until this top-
level display appears:
Three sub-displays are available (in the following sub-display order):
♦ Hp (10) Dose
♦ Hp (10)/h Dose Rate
♦ User ID Digits
Hp (10) Dose Display
Short-press the button to display the
current dose. This dose parameter is
used for tactical dose monitoring (e.g.
per task etc.).
Display Range: 0µSv to >16Sv (auto
ranging)
Note: Over-range (> 1.0 Sv) is indicated with a flashing LCD display.
H
p
(10)/h Dose Rate Display
Short-press the button again to display
the current Hp(10)/h dose rate. Only
the first two significant figures of the
dose rate are displayed, the actual
reading is rounded down.
To Next Page
Loading...
