Thermo SAFE 2010 - Procedure for Replacement of Exhaust Filter

Page 28 / 35
INSTRUCTION MANUAL
SAFE 2010/MaxiSAFE 2010
81-09-IM.doc
12. Free the triangle eyes from hooks and belts.
13. Reconnect the belts to the lower hook in front.
14. Tighten the belts and lock the cam buckle by lifting up the pawl.
15. Coil the belts and fasten them with the cable and wire ties.
16. Reinstall the front cover.
11.1.3. Procedure for replacement of exhaust filter
Exhaust filter
Screw
Bracket
Clamp hold
Exhaust fan
Figure 7.
1. Position the front window in the upper position.
2. Open the front-cover.
3. Disconnect from mains.
4. Using the screwdriver dismantle the front cover, avoid the cover falls.
5. Loosen the screw in front of the filter in order to remove the rails from the frame.
6. Remove the rails and the screw completely using the size 13-mm wrench.
7. Remove the filter without damaging the gasket.
8. Install the new filter.
9. Tighten the frame by suspending it while the rails are moved into place.
10. Check from above that the filter is positioned correctly with the gasket positioned equally on
all surfaces.
11. Tighten the screw until the gasket has a good contact to all sides.
12. Reinstall the front cover.