Using recording features
25
Refer to the following table to set the Parking Mode options.
Option Operation description
LED indicators
Status LED (STATUS) Recording LED (REC)
Motion
detection
No
motion
or impact
detected
Monitors movement in the area or impacts
to the vehicle. Video will be recorded only
when motion or an impact is detected.
(solid) (solid)
Motion
detected
When a moving objects is detected while
parking, a video is recorded for 20 seconds,
from 10 seconds before detection to 10
seconds after detection, and stored in the
Parking record folder.
(solid) + (flicker)
Impact
detected
When an impact is detected while parking,
a video is recorded for 20 seconds, from the
moment 10 seconds before detection to 10
seconds after detection, and stored in the
Parking incident folder.
(solid) + (flicker)
Time
Lapse
No
impact
detected
A videos is recorded at a rate of 2 fps for 10
minutes, compressed into a 2-minute long
file, and stored in the Parking record folder.
Since the video file recorded with this
option is small, you can record a long video.
(solid) (solid)
Impact
detected
When an impact is detected while parking,
a video is recorded for 100 seconds
at a rate of 2 fps, from the moment 50
seconds before detection to 50 seconds
after detection, and stored in the Parking
incident folder after being compressed
into a 20-second long file. (The buzzer will
sound.)
(solid) + (flicker)
OFF
The product is powered off when electric
accessories and the engine are turned off.
Off
•You cannot use Motion detection and Time Lapse at the same time.
•The Status LED will be green (
) when voice recording ( ) is diabled.
If parking mode settings are changed, the videos recorded with the previous settings will be deleted. To
prevent data loss, back up all parking mode videos before changing parking mode settings.
To Next Page
Loading...
