Thinkware T700 - Advanced Settings and Safety Features; Parking Mode and Battery Settings; Road Safety Features Configuration

Settings
33
Options Description
Impact Sensitivity in Parking
Mode
Select the desired parking mode sensitivity from Lowest/Low/Mid/High/Highest.
Motion Detection Sensitivity
Select the desired motion detection mode sensitivity from Lowest/Low/Mid/High/
Highest.
Record Timer
Select the desired record time from Disabled/3hrs/6hrs/12hrs/24hrs/48hrs/72hrs.
Battery Protection
Select from Enable/Disabled.
Battery cutoff voltage
Select the desired voltage from 12V (11.6-12.3)/24V (23.2-24.6).
Wintertime Battery Protection
Select the month(s) to apply the battery protection feature.
• To use parking mode, you must install the hardwiring cable. If continuous power is not supplied to the
product, the product will stop recording when the vehicle engine is turned off.
• The vehicle battery will not be charged while the vehicle is parked. If you record in parking mode for an
extended period, the vehicle’s battery may be depleted and you may not be able to start the vehicle.
• For more information about parking mode, refer to "3.5 Using parking mode" on page 21.
• The battery cutoff voltage can be set only when the Battery Protection setting is set to Enabled.
• If the off voltage value is too low, the product may consume the battery completely depending on the
conditions like the vehicle type or temperature.
7.4 Setting road safety features
From the mobile viewer, tap Dash Cam settings
>
Road Safety Settings to manage the road safety features
settings.
Options Description
Safety Cameras
Select from Enable/Disabled.
Mobile Zone Alert
Select from Enable/Disabled.
Vehicle Type
Select the vehicle type from Sedan/SUV/Truck (Bus).
Initialize ADAS
In Initialize ADAS, tap Initialize
>
OK to proceed with initializing.
LDWS
(Lane Departure Warning)
Select the desired LDWS sensitivity from Disabled/Low/Mid/High.
LDWS Speed
Select the desired LDWS detection speed from 50km/h / 60km/h / 80km/h /
100km/h.
FCWS
(Forward Collision Warning)
Select the desired sensitivity from Disabled/Low/Mid/High.
Low Speed FCWS
Select the desired sensitivity from Disabled/Low/Mid/High.
FVDW (Front Vehicle Departure
Warning)
Select from Enable/Disabled.