This menu is used to select the input source. In the [UTILITY] menu, select the ‘System Utilities’
option and confirm with [ENTER].
Select the ‘Input Source’ menu item and confirm with [ENTER]. The active input source is shown
on the display.
Select the required operating mode with [PM2] or [PM3] and confirm by pressing [ENTER] to
apply the new setting.
This menu is used to set the noise generator. In the [UTILITY] menu, select the ‘System Utilities’
option and confirm with [ENTER].
Select the ‘Noise Generator’ menu item and confirm with [ENTER]. The display shows the type
and volume of the noise generator. Select the type or noise generator with [PM2] or the
volume with [PM3] and confirm by pressing [ENTER] to apply the new setting.
In this menu you can link the two input channels. In the [UTILITY] menu, select the ‘System
Utilities’ option and confirm with [ENTER].
Select the ‘Link Input’ menu item and confirm with [ENTER].
Select the required operating mode with [PM2] or [PM3] and confirm by pressing [ENTER] to
apply the new setting.
"System Utilities" – "Input
Source"
"System Utilities" – "Noise Gen‐
erator"
"System Utilities" - "Link Input
CH 1/2"
Operating
digital speaker management system
24
To Next Page
Loading...