thomann T.racks DSP 26 - Input Channel Naming; Input Noise Gate Adjustment; Input Gain Level Control

This menu is used to edit the name of the input signal. Press [A] or [B] to activate the edit mode
for channel A or B and to open the ‘Input A/B’ menu. Press [ENTER] to change the name in the
‘Name’ menu.
Use [NAV/PAR1] to select the letters to be edited; use [PM2] or [PM3] to change the letters.
Pressing [ESC] exits the menu item.
This menu is used to adjust the settings of the noise gate. Press [A] or [B] to activate the edit
mode for channel A or B and to open the ‘Input A/B’ menu. Press [ENTER] to make the relevant
settings in the ‘Noise Gate’ menu.
Use [NAV/PAR1] to change the level to be edited; use [PM2] or [PM3] to change the displayed
parameters ‘Bypass’ and ‘Threshold’ or ‘Release’ and ‘Attack’. Confirm to save the new setting
with [ENTER]. Pressing [ESC] exits the menu item.
This menu is used to lower or raise the level of the input signal in a range from –12 dB to
+12 dB. Press [A] or [B] to activate the edit mode for channel A or B and to open the ‘INPUT A/B’
menu. Press [ENTER] to make the relevant settings in the ‘Gain’ menu.
Use [PM2] or [PM3] to adjust the level of the input signal as required. Confirm the new setting
with [ENTER].
Pressing [ESC] exits the menu item.
"Name"
"Noise Gate"
"Gain"
Operating
DSP 26
37