Chapter 5
Expert Configuration
E-DOC-CTC-20050429-0104 v1.0
126
IP The IP section bundles all expressions that express a relation based on IP addresses.
The Expressions table provides following information per expression:
The Name of the expression
A Summary of the expression’s configuration.
For more detailed information you can expand the expression (click ).
Adding an IP related
expression
To add a new IP related expression:
1 Click New.
2 In the IP Expressions Properties table:
Type a Name for the expression.
Type an IP address or an IP address range. For negative logic, select Not.
3 Click Apply to add the expression to the table.
Service The Service section bundles all expressions that express a relation based on services.
The Expressions table provides following information per expression:
The Name of the expression
A Summary of the expression’s configuration.
For more detailed information you can expand the expression (click ).
Adding a service
related expression
To add a new service related expression:
1 Click New.
2 In the Service Expressions Properties table:
Type a Name for the expression.
Select a Protocol to filter on. For negative logic, select Not.
Type a Source port from... to... to define the source port range. For
negative logic, select Not.
Type a Destination port from... to... to define the the destination port
range. For negative logic, select Not.
3 Click Apply to add the expression to the table.
You can define a valid IP address range by:
Typing a subnet, e.g. 10.0.0.0/8
Typing a IP address subset range, e.g. 10.[1-31].[9-11].[1-5]
Using wild cards, e.g. 192.5.*.*
To Next Page
Loading...
