Chapter 8
Troubleshooting
E-DOC-CTC-20050429-0104 v1.0
199
8.3 Reset to Factory Defaults
Resetting your
SpeedTouch™
You might consider a reset to factory defaults as described below.
You can choose between:
Hardware reset
Software reset
A reset to factory default settings deletes the configuration profile settings.
Therefore, after the reset, a reconfiguration of your SpeedTouch™ will be needed.
Also your WLAN clients will have to be re-associated, as described in
“2.2.2 Connecting First-time Wireless Clients” on page 24.
Hardware reset Proceed as follows:
1 Make sure the SpeedTouch™ is powered on.
2 Use a pen or an unfolded paperclip to push the recessed reset button on the
back panel. The reset button is marked with a red circle. Keep it pushed until
the power LED lights red - this will take about 7 seconds.
3 Release the reset button.
4 The SpeedTouch™ restarts.
!
Be aware that a reset to factory defaults will revoke all configurational
changes you made to the SpeedTouch™.
!
Your system administrator may have disabled the physical reset button of
the SpeedTouch™. In this case, a hardware reset to defaults is not possible.
15VAC
Reset
2 3 4
ON
OFF
Console
1
ISDN
Asso-
ciation
To Next Page
Loading...
