Chapter 2
Bridged Ethernet
E-DOC-CTC-20051017-0167 v1.0
15
The Bridge interface Proceed as follows to create, configure and attach/connect the bridge interface:
1 Create a new bridge interface with name BrETHoA_br.
2 Configure the new bridge interface with as destination the ATM interface
created above.
3 The Bridged Ethernet interface is not yet connected. Connect the bridge
interface.
4 Execute saveall at the prompt to save this configuration.
=>eth bridge ifadd intf=BrEthoa_br
=>
=>eth bridge ifconfig intf=BrEthoa_br dest=BrEthoa_atm
=>
=>eth bridge ifattach intf=BrEthoa_br
=>
=>saveall
=>
For a complete description of all CLI commands, see the
SpeedTouch™ CLI Reference Guide.
To Next Page
Loading...
