THOMSON SpeedTouch - 6.1 SpeedTouch PPPoE Relay Configuration; Description

Chapter 6
PPPoE Relay
E-DOC-CTC-20051017-0167 v1.0
51
6.1 SpeedTouch™ PPPoE Relay Configuration
Description In this scenario, the end users are connected either via IP or PPPoE. Traffic is sent
over the same VP/VC to the Internet.
Setup The figure below shows the setup for the example scenario:
 an embedded PPP client on the SpeedTouch™ (red)
 a host PPP client on a PC on the LAN (blue)
Configuration scenarios Two scenarios exist for configuring the SpeedTouch™ Relay. This section gives an
example of the configuration procedure for both scenarios:
1 General configuration scenario
2 Configuration making use of ILMI (autopvc)
Both PPPoE connections (external and embedded) can use different Access
Concentrators.
DSLAM
VP/VC: 8/35
BRAS
Internet
Public IP address
Embedded
PPPoE
IP
PPPoE
PPPoE
IP client with
local IP address
Public
IP address