THOMSON SpeedTouch - 6.1.2 Configuration making use of ILMI [autoPVC]

Chapter 6
PPPoE Relay
E-DOC-CTC-20051017-0167 v1.0
57
6.1.2 Configuration making use of ILMI (autoPVC)
Configuration procedure Proceed as follows to configure the PPPoE Relay interface using ILMI:
1 Add a new (embedded) PPP interface.
2 Configure the PPP interface (user name and password for the ISP) and with
destination RELAY.
3 Create a route that will be added to the routing table when the PPP link comes
up.
4 Configure the PPP relay.
5 Activate the autoPVC.
6 Execute save all at the prompt to save this configuration.
=>ppp ifadd intf=autoPPP
=>
=>ppp ifconfig intf=autoPPP user=johnDoe@ISP password=johnDoe
dest=RELAY
=>
=>ppp rtadd intf=autoPPP dest=0.0.0.0/0
=>
=>ppp relay ifadd intf=bridge
=>ppp relay ifadd intf=autoPPP
=>
=>autopvc config mode=active type=pppoerelay
=>
=>saveall
=>
For a complete description of all CLI commands, refer to the SpeedTouch™
CLI Reference Guide.