EasyManua.ls Logo

THOMSON SpeedTouch - 5.1 SpeedTouch Routed PPPoE Configuration; Preparatory steps for using Routed PPPoE

THOMSON SpeedTouch
110 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 5
Routed PPPoE
E-DOC-CTC-20051017-0167 v1.0
39
5.1 SpeedTouch™ Routed PPPoE Configuration.
Preparatory steps for
using Routed PPPoE
To be able to configure the SpeedTouch™ successfully for the Routed PPPoE Packet
Service, the following information must be available:
The VPI/VCI value of the Virtual Channel on which the PPPoE connection
service is enabled.
The encapsulation method (normally LLC/SNAP).
The Routed PPPoE interface’s IP configuration, either via single IP address, or
via IPCP subnet masking. The latter configuration requires all local nodes to be
configured for DHCP and the SpeedTouch™ DHCP server being active.
The user name and password for the ISP account.
Optionally, a Service name and/or Access Concentrator name.

Table of Contents

Related product manuals