THOMSON SpeedTouch - 1.2 The SpeedTouch Interfaces

Chapter 1
Introduction
E-DOC-CTC-20051017-0167 v1.0
6
1.2 The SpeedTouch™ Interfaces
Types of interfaces In the SpeedTouch™ release R5.4 and higher, there are five different types of
interfaces:
 Physical interfaces:
Interfaces that can be connected to other peripherals from outside the box:
 Physical Ethernet interface
 USB interface (USB 1.1 slave)
 IEEE 802.11b/g WiFi Access Point
 ISDN modem interface
 DSL interface
 ATM interfaces:
Interfaces that are created on top of an ATM address, or in case of an ATM
bundle, on top of another ATM interface.
 Ethernet interfaces:
Interfaces that are created on top of a physical interface, bridge, ATM
interface, or in case of VLAN, on top of another Ethernet interface.
 IP interfaces:
Interfaces that are created on top of an Ethernet interface, an ATM interface or
exist on top of a PPP interface.
 PPP interfaces:
Interfaces that are created on top of:
 an Ethernet interface
 an ATM interface
 the ISDN interface
 the PPPoE Relay