Chapter 1
Introduction
E-DOC-CTC-20051017-0167 v1.0
7
Schematic overview The figure below shows the SpeedTouch™ interface architecture.
Configuration procedure The configuration of an interface always exists of following three steps:
1 Creating the interface.
2 Configuring the interface.
3 Attaching the interface to its lower layer interface.
Every packet service consists of the configuration of different interfaces on top of
each other.
In this document interfaces are configured by means of:
The Command Line Interface (CLI)
The Setup Wizard
PPP
PPPoA
IPoA
iARP
PPPoEIPoE /
IPoEoA
ARP
PPPoE RELAY
Multilink
PPP
EthoA
IP Interface(s)
IP Forwarding
Physical Ports
(Eth, USB, WLAN, BT...)
ATM VP/VC
(Over DSL / ATM-F)
ISDN
LoopBack
Ethernet Interface(s)
ATM Interface(s)
Bridge
VLAN
ATM Bundle
To Next Page
Loading...
