THOMSON SpeedTouch - 10.2.2 How to Configure the PPP Connection

Chapter 10
Routed PPPoI
E-DOC-CTC-20051017-0167 v1.0
88
10.2.2 How to Configure the PPP Connection
How to Configure the PPP
Connection Via the Web
Interface
If you used the Web interface to configure the Dial-In connection, you do not need
any additional configuration.
How to Configure the PPP
Connection Via CLI
Use the following command sequence to configure the PPP connection via CLI:
[ppp]=>ifconfig
intf = bu_isdn
[dest] = buisdn
[user] = cpesit@rednet
[password] =
[pcomp] = disabled
[accomp] = enabled
[trace] = disabled
[auth] = auto
[restart] = enabled
[retryinterval] = 10
[passive] = disabled
[silent] = disabled
[echo] = enabled
[mru] = 1500
[laddr] =
[raddr] =
[netmask] =
[format] =
[format] = none
[pool] =
[savepwd] = enabled
[demanddial] = enabled
[doddelay] = 30
[primdns] =
[secdns] =
[dnsmetric] =
[idletime] = 45
[idletrigger] = Tx
[unnumbered] = disabled
:ppp ifconfig intf=bu_isdn format=none
[ppp]=>