THOMSON SpeedTouch - The IP interface; IP address assignment

Chapter 9
Routed IPoA
E-DOC-CTC-20051017-0167 v1.0
79
The IP interface Proceed as follows to create, configure and attach/connect the IP interface:
1 Add a new IP interface with as destination the ATM interface created above.
2 Connect the IP interface.
IP address assignment Proceed as follows to assign an IP address to the IP interface:
1 Should the Routed Ethernet interface IP settings be obtained dynamically via
DHCP?
 If yes, go to step 2.
 If no, go to step 3.
2 Configure the DHCP client interface.
Proceed with step 5.
3 Enter the static IP address (e.g. 202.202.202.66) and netmask (e.g.
255.255.255.0) for the local side of the Ethernet connection. In case of a point-
to-point link, enter the remote address. These should be provided by your ISP.
4 Optionally, make this interface your default gateway.
5 Execute saveall at the prompt to save this configuration.
=>ip ifadd intf=RtIPoA_ip
=>:ip ifadd intf=RtIPoA_ip dest=RtIPoA_atm
=>
=>:ip ifattach intf=RtIPoA_ip
=>
=>dhcp client ifadd intf=RtIPoA_ip
=>dhcp client ifattach intf=RtIPoA_ip
=>
=>:ip ipadd addr=202.202.202.66/24 pointtopoint=202.202.202.1
intf=RtIPoA_ip
=>
=>:ip rtadd dest=0.0.0.0/0 intf=RtIPoa_ip
=>
=>saveall
=>
For a complete description of all CLI commands, see the
SpeedTouch™ CLI Reference Guide.