TSC 7320 Transfer Switch Controller
PM180 REV 0 23/02/10 Thomson Power Systems
30
5.2. SYSTEM TIME/DATE ADJUSTMENT
To adjust the TSC 7320 controller’s internal time clock, follow the detailed procedure below.
With the TSC 7320 powered on, navigate to the restricted area of the settings, and login
Find the page with the “Editor - Display” heading. If the date and time is not listed, the up or
down navigation button may need to be pressed to show the setting
Press the center checkmark button and the seconds setting will start to flash. Use the up or
down navigation keys to change the value of the flashing setting, and the left and right keys
to change which part of the date and time is being edited.
Change all parts of the time and date to match the desired values and press the center
checkmark to save the changes.
Once the correct time and date is entered, hold the center checkmark to exit the editor mode.
To Next Page
Loading...
