TSC 7320 Transfer Switch Controller
PM180 REV 0 23/02/10 Thomson Power Systems
33
6. Complete: The voltage change procedure is now complete. If the voltage settings need to
be adjusted from their default values, please refer to SECTION 5.1 of this document for
further details on entering the restricted area of the settings, and how to change values.
5.4. EXERCISE TIMER SETUP
The TSC 7320 controller has a built-in calendar based programmable exercise timer. The
exercise timer has two banks that can be programmed on either weekly or monthly period. Each
of the banks has 8 schedules within them that can be set to a specific week, day, and time. For
a given schedule, the type of test and duration can be inputted. The exercise timer utilizes an
internal real-time clock for referencing all timing functions. The controller’s real-time clock utilizes
a battery back-up power source to retain correct time/date settings during short duration utility
power failures.
5.4.1. ADDING / EDITNG NEW EXERCISE SCHEDULE EVENT
Login to the restricted area of the controller settings, refer to SECTION 5.1.2 for further
details. After entering the restricted settings area, use the left or right buttons and
navigate to the “Editor – Schedule” page. Here the scheduler can be activated, or
deactivated.
The up and down buttons can now be sued to cycle between all the scheduler settings.
When viewing a setting, the value can be changed by pushing the center checkmark
button, and then using the up and down buttons to change the value. If there is more
than one value that can be changed on the specific page, they can be cycled through
using the left and right buttons. When done, push the center button to save. Exit by
holding the center button for 5 seconds. Note: a duration of 0 will disable that
schedule.
To Next Page
Loading...
