THORLABS BSC202 User Manual

34 HA0278T Rev H Dec 2016
Chapter 4
4.12 Stage/Axis Tab
This tab contains a number of parameters which are related to the physical
characteristics of the particular stage or actuator being driven. They need to be set
accordingly such that a particular stage is driven properly by the system.
Fig. 4.14 Stage/Axis Tab
These parameters were set automatically when the HS Na noMax 300 X Axis stage
type was selected using the APTConfig utility in Section 3.6. The APT server
automatically applied suitable defaults for the parameters on this tab during boot up
of any client software such as APTUser. These parameters should not be altered for
pre-defined Thorlabs stages and actuators selected using APT Config, as it may
adversely affect the performance of the stage.
For custom stage types not available using the APT Config utility, the stage details
must be entered manually.
Individual parameters are described in Section 5.3.

THORLABS BSC202 Specifications

General

Brand	THORLABS
Model	BSC202
Category	Controller
Language	English