Appendix E
62 HA0278T Rev H Dec 2016
GetTriggerParams Gets the move triggering parameters.
GetVelParamLimits Gets the maximum velocity profile parameter limits.
GetVelParams Gets the velocity profile parameters.
GetVelParams_Accn Gets the move acceleration (returned by value).
GetVelParams_MaxVel Gets the mo ve maximum velocity (returned by
value).
Identify Identifies the controller by flashing unit LEDs.
LLGetDigIPs Gets digital input states encoded in 32 bit integer.
LLGetStatusBits Gets the controller status bi ts encoded in 32 bit
integer.
LLSetGetDigOPs Sets or Gets the user digital output bits encoded in
32 bit integer.
LoadParamSet Loads stored settings for specific controller.
MoveAbsolute Initiates an absolute move.
MoveAbsoluteEnc Initiates an absolute m ove with specified positions
for encoder equipped stages.
MoveAbsoluteEx Initiates an absoloute move with specified positions.
MoveAbsoluteRot Initiates an absolute m ove with specified positions
for rotary stages.
MoveHome Initiates a homing sequence.
MoveJog Initiates a jog move.
MoveRelative Initiates a relative move.
MoveRelativeEnc Initiates a relative move with specified distances for
encoder equipped stages.
MoveRelativeEx Initiates a relative move with specified distances.
MoveVelocity Initiates a move at constant velocity with no end
point.
SaveParamSet Saves settings for a specific controller.
SetAbsMovePos Sets the absolute move position.
SetBLashDist Sets the backlash distance.
SetChannelSwitch Sets the GUI channel switch position.
SetDispMode Sets the GUI display mode.
SetEncCalibTableParams Sets the encoder calibration table parameters for
encoder equipped stages.
SetEncPosControlParams Sets the encoder position control parameters fo r
encoder equipped stages.
SetEncPosCorrectParams Sets the encoder position correction parameters for
encoder equipped stages.
To Next Page
Loading...
Need help?
General
