12
Chapter 3 Getting Started
3.1 Install The Software.
DO NOT CONNECT THE CONTROLLER TO YOUR PC YET
1) Go to Services/Downloads at www.thorlabs.com and download the APT software.
2) Run the .exe file and follow the on-screen instructions.
Note
This section is applicable only if the K-Cube is to be used with a PC. If your
application consists only of local operation via the K-Cube front face, proceed
to Section 3.2.
When operating via a PC, direct user interaction with the Piezo driver is
accomplished through intuitive graphical user interface panels (GUIs), which
expose all key operating parameters and modes. The user can select multiple
panel views displaying different information about a particular hardware unit.
The multitasking architecture ensures that the graphical control panels always
remain live, showing all current hardware activity.
Cautions
Some PCs may have been configured to restrict the users ability to load
software, and on these systems the software may not install/run. If you
are in any doubt about your rights to install/run software, please consult
your system administrator before attempting to install.
If you experience any problems when installing software, contact
Thorlabs on +44 (0)1353 654440 and ask for Technical Support.
To Next Page
Loading...
Need help?
General
