69
K-Cube Piezo Driver
GetKCubeTriggerParams Sets the triggering parameters
GetOutputLUTParams Gets the output voltage waveform (LUT) operating
parameters.
GetOutputLUTTrigParams Gets the output voltage waveform (LUT) triggering
parameters.
GetOutputLUTValue Gets a specific voltage output value in the voltage
waveform (LUT) table.
GetVoltOutput Gets the HV output voltage.
GetVoltageOutputLimit Gets the HV output voltage maximum limit.
Identify Identifies the controller by flashing unit LEDs.
LLGetStatusBits Gets the controller status bits encoded in 32 bit
integer.
LLSaveHWDefaults Allows the current settings of the operation
parameters to b e saved into the onboard 'Flash'
memory of the hardware unit.
LoadParamSet Loads stored settings for specific controller.
SaveParamSet Saves settings for a specific controller.
SetControlMode Sets the loop operating mode (open/closed).
SetDispIntensity Sets the front panel LED display intensity.
SetHubAnalogueChanIn Sets the hub analogue input channel used for close
loop operation.
SetIPSource Sets the HV amplifier input source.
SetJogStepSize Sets the jogging step size.
SetKCubePanelParams Sets various parameters for the top panel controls
SetKCubeTriggerParams Sets the triggering parameters
SetOutputLUTParams Sets the output voltage waveform (LUT) operating
parameters.
SetOutputLUTTrigParams Sets the output voltage waveform ( LUT) triggering
parameters.
SetOutputLUTValue Sets a specific vo ltage output value in the voltage
waveform (LUT) table.
SetVoltOutput Sets the HV output voltage (open loop).
SetPosOutput Sets the output position (closed loop).
SetVoltageOutputLimit Sets the HV output voltage maximum limit.
ShowEventDialog Shows the event dialog when it has previously been
disabled using the EnableEventDlg method
StartCtrl Starts the ActiveX Co ntrol (starts com munication
with controller)
To Next Page
Loading...
Need help?
General
