Installation and Operational Instructions
for ROBA-stop
®
-silenzio
®
Type 896.213.30
Sizes 500 – 1800
Chr. Mayr GmbH + Co. KG Tel.: +49 8341 804-0 E079 10 228 000 471
Eichenstraße 1 Fax: +49 8341 804-421 Page 2 of 17
D-87665 Mauerstetten www.mayr.com
Germany E-Mail: info@mayr.com 21/06/2012 TK/HW/GF/SU
Guidelines on the Declaration of Conformity
A conformity evaluation has been carried out for the product (electromagnetic safety brake) in terms of the EC Low
Voltage Directive 2006/95/EC. The Declaration of Conformity is laid out in writing in a separate document and can be
requested if required.
Guidelines on the EMC Directive (2004/108/EC)
Due to their passive quality, brakes are also non-critical equipment according to the EMC.
Guidelines on the Machinery Directive (2006/42/EC)
The product is a component for installation into machines according to the Machinery Directive 2006/42/EC.
The brakes can fulfil the specifications for safety-related applications in connection with other elements.
The type and scope of the required measures result from the machine risk analysis. The brake then becomes a machine
component and the machine manufacturer assesses the conformity of the safety device to the directive.
It is forbidden to start use of the product until you have ensured that the machine accords with the regulations stated in the
directive.
Guidelines on the ATEX Directive
Without a conformity evaluation, this product is not suitable for use in areas where there is a danger of explosion.
For application of this product in areas where there is a high danger of explosion, it must be classified and marked
according to directive 94/9/EC.
Safety and Guideline Signs
Immediate and impending danger which can
lead to severe physical injuries or to death.
Danger of injury to personnel and damage to
machines.
Please Observe!
Guidelines on important points.
TÜV (German Technical Inspectorate) Certificates
EC Type Examination Certificate
Type Examination Certificate
To Next Page
Loading...
