3.2 The permissible load on the front of the machine
The maximum permissible load on the lifting arms is shown in the diagram below
The load must be positioned in the middle between the front wheels.
In the load table, point 0 is shown on the lifting arm handle if it is in a vertical (upright)
position. It is measured from the handle on the lifting arms where the quick coupler is
connected (quick coupler device).
For example, the arms may lift 150 kg with a load placed 800 mm away from handle without
loading the rear end. When minimal load amounting to 200 kg is on the rear end, the arms
may lift 300 kg at the same distance.
0
50
100
150
200
250
300
350
400
450
500
-800 -400 0 400 800 1200 1600 2000 2400 2800
Kg
mm
Přípustné zatížení vpředu
žádné zatížení vzadu zatížení vzadu-min. 200 kg
To Next Page
Loading...
