is thus only possible
by activating the brake pedal.
12.5 Starting and stopping attached tools (attachments)
Connecting the oil motor when the diesel motor is at high (rotational) speeds may cause high
pressure maxima in the hydraulic system. In extreme cases, the pump may be damaged or its
life span may be shortened. Starting and stopping attached tools with oil motors must be done
in the following manner:
Starting attached tools
1. Decrease the speed (revolutions) of the diesel motor below 1500 rev/min.
2. Activate the front and rear power take off (PTO).
3. Increase the speed (revolutions) of the diesel motor to the required level.
Stopping attached tools
1. Decrease the speed (revolutions) of the diesel motor below 1500 rev/min.
2. Turn off the front and rear power take off (PTO).
3. The speed (revolutions) of the diesel motor may now be set to the required level.
Attaching tools to the lifting arm
Never operate the machine with tools unless the quick hitch is in a locked (secured) position.
It is necessary to carefully wipe all the quick couplings (plus and minus) before mounting
tools in order to prevent dirt from getting into the hydraulic system.
It is important that the hydraulic hoses be the correct length when attaching new tools.
To Next Page
Loading...
