14.3 Changing the motor oil filter
- Drain the motor oil through the drain plug on the lower lid of the crankcase.
The service port for the drain plug is located on the base plate of the rear chassis
frame.
- Pull the old oil filter out.
- Coat the new filter housing washer with a small amount of oil.
- Quickly screw the filter until it connects to the mounting surface.
- Screw the filter manually by rotating it by a half turn
- Fill the filter with the new oil to the required level
IMPORTANT: Only use the original KUBOTA filter in order to prevent serious
motor damage.
(1) Drain plug, the oil drain must be within this range A) Oil level
(2) Oil level meter
(3) Filling oil
(4) Oil filter
To Next Page
Loading...
