EasyManua.ls Logo

Timan VPM-3400 - Air Filter Maintainence; Engine and Cabin Air Filters

Timan VPM-3400
145 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE
37
16 AIR FILTER MAINTAINENCE
16.1 MOTOR SUCTION FILTER
With model VPM 3400, the intake air is cleaned by an air filter with 2 inserts before it enters
the motor. In order to ensure the required filtration, it is necessary to keep both filters clean.
- As the dust filter is a type of dry filter, oil must never be added to the filter.
- If the inner portion of the air filter housing is dirty or wet, clean it with a clean
piece of cloth.
- Try not to touch it, only during cleaning.
- If dust has settled on the part, blow it out with compressed air from the inside.
Use a min. air pressure of 7 bar or 99 psi.
- If the part is brought into contact with carbon or oil, immediately replace the
filter.
- The filters are replaced after 150 operating hours.
IMPORTANT: Make sure the brackets for tightening various parts of the filter are tightened
properly. If they loosen up, dust and dirt can be sucked in and damage the cylinder liner and
piston rings.
16.2 Pollen filter in the cab
The cab's air device is equipped with a pollen/dust filter, to prevent particles from the
surrounding area from getting into the cab. The filters are located at the rear end of the cab on

Table of Contents

Related product manuals